no one uses conduit in residential wiring my friend... it's a lot more expensive and un-necessary. A typically 2 x 4 is 3.5 inch, half is 1.75 inch. You just need to drill in the middle of the 2 x 4. Wiring going thru stud is considered supported.
-jeffrey815(Smartiecat);
2016-11-21(#10438761@0)
Or if you do going thru at less than 1.25 inch to the edge, just install steel plate. They are 25 cents each... Way cheaper and faster than running B/X wires.
-jeffrey815(Smartiecat);
2016-11-21(#10438768@0)
just use long flexible bit. It can be 6 feet long.... After you drill, just put the wire at the end and pull it back...
-jeffrey815(Smartiecat);
2016-11-21(#10438903@0)+1
Nope... Demolition took place in July this year. Before that we were just planning so I asked lots of questions. We are 5 months into the project only.
-jeffrey815(Smartiecat);
2016-11-21(#10437977@0)
It is to code, secure to wood every 1.5m and within 30cm of the fixture. I leave it loose in between as recommended by the book.
-jeffrey815(Smartiecat);
2016-11-21(#10438521@0)
